"A206SH" here refers to this mobile phone "AQUOS ケータイ4."
Do not disassemble or modify handset.
Hereby, SHARP CORPORATION declares that the radio equipment type A206SH is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://jp.sharp/k-tai/
Manufacturer's Address:
SHARP CORPORATION,
1 Takumi-cho, Sakai-ku, Sakai-shi,
Osaka 590-8522, Japan
Item | Description | |
---|---|---|
GSM 900 | Tx 880.2 to 914.8 MHz Rx 925.2 to 959.8 MHz |
|
DCS 1800 | Tx 1710.2 to 1784.8 MHz Rx 1805.2 to 1879.8 MHz |
|
WCDMA FDD I | Tx 1922.4 to 1977.6 MHz Rx 2112.4 to 2167.6 MHz |
|
WCDMA FDD VIII | Tx 882.4 to 912.6 MHz Rx 927.4 to 957.6 MHz |
|
LTE Band 1 | Tx 1922.5 to 1977.5 MHz Rx 2112.5 to 2167.5 MHz |
|
LTE Band 3 | Tx 1710.7 to 1784.3 MHz Rx 1805.7 to 1879.3 MHz |
|
LTE Band 8 | Tx 880.7 to 914.3 MHz Rx 925.7 to 959.3 MHz |
|
Bluetooth | Tx 2402 to 2480 MHz Rx 2402 to 2480 MHz |
|
WLAN 2.4 GHz | Tx/Rx 2412 to 2472 MHz (BW:20 MHz only) | |
GNSS | GPS:Rx L1 (1575.42 MHz) GLONASS:Rx G1 (1598.0625 to 1605.375 MHz) BeiDou:Rx B1 (1561.098 MHz) |
Item | Description | |
---|---|---|
GSM 900 | +33 dBm (Power Class4) | |
DCS 1800 | +30 dBm (Power Class1) | |
WCDMA FDD I | +24 dBm (Power Class3) | |
WCDMA FDD VIII | +24 dBm (Power Class3) | |
LTE Band 1 | +23 dBm (Power Class3) | |
LTE Band 3 | +23 dBm (Power Class3) | |
LTE Band 8 | +23 dBm (Power Class3) | |
Bluetooth | +10.5 dBm (Power Class1) | |
WLAN 2.4 GHz | +15.0 dBm |
Use specified Battery or Charger only.
Non-specified equipment use may cause malfunctions, electric shock or fire due to battery leakage, overheating or bursting.
Do not dispose of an exhausted Battery with ordinary refuse; always tape over Battery terminals before disposal.
Take Battery to a Y!mobile Shop, or follow the local disposal regulations.
Charge Battery in ambient temperature 5oC - 35oC; Battery may leak/overheat and performance may deteriorate outside this range.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
:This symbol means the stand-by on/off.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.
■FCC Information to User
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.